One thing I did not shown here and is very important I put masking tape to cover all the mounting holes. I then filled the mover pipe with hydraulic cement !!! I let the cement dry for a couple of days to dry like iron. Then take the masking tape off and use the same drill bit to drill out the cement in the mounting holes to clean the cement out for the 1 meter mounting bolts. If I was to tighten the mount without the hydraulic cement inside the pipe would crush since it is a softer die cast aluminum metal.

The 3 bolts fitting the exact diameter of the holes do not give you any adjustment or play since the dish has to be perpendicular to the mover anyway. I could have drilled the holes a little higher but I think from the picture above I was getting close to the coax connections. I just might drill another hole to move it up a bit raising it another 1.25 inches.

One thing for sure is I have a rock solid dish on a mover just waiting to drain any transponder dry.

Enjoy!!!!

NEXT>>